![]() We would never recommend the user to do this, especially if there are life safety devices enrolled in the system. The Lyric is enclosed, and does not offer a way to physically disconnect the speaker wire. Note: Some older Lynx Touch panels had an exposed cable between the board and the siren that could be physically disconnected. ![]() To test the fire alarm siren, set off a fire panic, or trigger a fire security device that is programmed to the system. A list of devices including the base station cameras displays. however, after selecting there is no volume button. Unfortunately, due to low manpower, they will have 2nd and on occaision 3rd requests. 2) The time for which the siren sounds is less than 15 seconds. To test the burglary siren, simply set off an audible burglary panic, or arm the system and open a zone to set off an alarm. according to user manual, below are the steps to adjust volume of siren. 1) When the FA siren sounds, it sounds the Westminster Abbey chimes sound so it is far from an obnoxious scary air-raid sound. If your system is monitored, make sure that you have put it on test with a central station before testing the siren. Click "Save" in the bottom right corner of the screen, and then go back to the home screen. Consider any local noise ordinances when setting these timeouts. The bell timeouts will tell the system when to disable the alarm sounds after a burglary or fire alarm. As stated above, there is no way to disable fire or CO alarm sounding. Set the "Burglary Alarm Sound" to "No." This will lower the volume on the burglary alarm sounds. This will load the siren's programmable fields. Starting on the home screen, click Security > More > Tools > Enter your Installer Code (the default is 4112) > Program > Press the down arrow on the right hand side of the screen > Sounder. Access the siren's programming options.To lower siren volume in system programming: The beep is loud enough to hear outside of the home, and gives a user confirmation that they have successfully armed or disarmed the system. For this reason, Arm Confirm is very useful for key fobs. The Arm Confirm setting has the system produce a loud beep when it's armed, based on what this field is set to. The Burglary Bell Timeout and Fire Bell Timeout settings determine how long the siren will sound in a burglary or fire alarm event. The specific setting for the siren is titled “Burglary Alarm Sound.” Other program options available include Burglary Bell Timeout, Fire Bell Timeout, and Arm Confirm. The sounder's settings menu can be found in system programming. If it's toggled off, it won't re-enable itself, and must be toggled to "ON" for normal operation. When set to “OFF,” it will still sound at a low level. ![]() The siren must be unplugged from the unit to be shut off completely. The L5210's internal siren cannot be fully turned off in programming.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |